Tail motor wire and connector for micro helis.

2-pin male connector soldered to a 24" loop of magnet wire.

For the tail motors of Eflite MCP-X helis and others.

Exposed soldered area covered with a thin application of liquid electrical tape to prevent shorts.

Will make up to a 12" long lead, long enough for even extended booms (please make sure this is long enough for you!)

Wire is in a loop to assist in pulling thru your tail boom - use your old wires, thin spring wire or thicker mono-filament wire to pull this thru, then cut to length and solder to your tail motor.

Note - This is 'solderable' magnet wire, you do not need to scratch or sand off the enamel. I solder most of the time at 600* F, but need to go to 800* F to get the enamel on this wire to melt.

Available in either 28 gauge (estimated to be stock) or 26 gauge (thicker for less power loss).

Prototypes with exactly 24" of wire, connector and insulation weighed 0.50 grams for 28 gauge and 0.75 grams for 26 gauge.

BE SURE TO SELECT YOUR CHOICE OF GAUGE BELOW!