Use your existing 2S Lipos on your minideans connected ESC

This is the "JST" female connector wired to a minideans clone, with the positive part of the minideans clone exposed

Note - make sure the polarity of your connector is correct before plugging in.

Also note - I think this adapter is BAD for you, and of backwards design. Of course this is designed to take your JST-M battery and plug it into an ESC with MiniDeans. BUT when you leave this adapter attached to your battery, the positive pin is now exposed, leaving you with a higher chance of shorting it out. I personally leave the negative wire exposed on minideans batteries, and I think most other people do to.

SO - leave this adapter IN YOUR PLANE, NOT ON YOUR BATTERY.

I only made this connector for the "Great Planes 30mm Brushless Micro EDF F-86 Sabre". In that plane, specifically the NEW battery they made for it, they've put the positive pin exposed. A customer wanted to use his batteries with JST males on it, so here we go.

Also Also Note - this will make any JST-Male 2S battery look just like an Electrifly BP200 15C battery